Table of Contents
Advertisement
Problem
Machine does not start
7.6 Drawings and schemes
The drawings accompanying this machine are supplied in a separate file. The wiring diagrams are included in the
electrical cabinet of the machine.
7.7 Spare parts
Only original spare parts and accessories of Javo BV may be used on the machine.
Javo BV advises you to take certain parts in stock because of wear sensitivity and / or any expected downtime for re-
ordering of the parts.
The spare parts list can be found on the assembly drawings. These can be found on JavoNet.
When ordering (spare) parts at Javo BV, the following information must be included: drawing number, item number,
desired length (if applicable) and the desired number of pieces.
7.8 JavoNet
We recommend you to register your machine on JavoNet. This way you get online access to all
technical drawings and documents pertaining to your machine.
Visit our website (www.javo.eu) for more information and to request an account.
7.9 Customer support and advice
Our technical department will answer your other questions about repair and maintenance of your machine and
spare parts. We can help you with any questions regarding the purchase, use and settings of products and
accessories.
Version 2016-2
Possible cause
Door safety switch is open
Emergency stop button is not
pulled
Emergency stop button not reset
Breaker tripped in main cabinet
Cable length too large causing
voltage loss
Voltage fluctuations caused by
other devices on the same group
Control switch for height format
sets is operated.
Action / Solution
Close door and reset the safety circuit by pressing
the reset button
Pull Emergency Stop button and reset the safety
circuit by pressing the reset button
Reset the safety circuit by pressing the reset button
See why circuit breaker has tripped. Remove
obstacles to conveyors. Switch on the machine
after solving the problem.
Reduce cable length
Ensure the correct voltage. Turn off other devices
Set Format-set so height in a way that sensor
remains down.
Remove excess soil at the sensor.
Remove misfed trays.
User Manual Javo Matrix
19
Advertisement
Table of Contents
