Set Compactor Height; Set Substrate Slide Height; Set Brush Height - Javo Matrix User Manual

5.10 Set compactor height

Set the compactor height before you start working with the
machine.
Procedure:
1. Check the compactor height with respect to the tray.
The compactor should not touch the format-set plates. There
should be a gap of about 10mm.
2. If the height is incorrect:
a. Loosen clamp (A).
b. Turn the compactor to the desired height with crank (B).
i. The lower the compactor is over the tray, the harder the ground tension will be.
ii. The higher the compactor is over the tray the softer the ground tension will be.
c. Tighten clamp (A).
The substrate slide moves with the height adjustment of the rotorbin. Adjust slide after setting the rotor
height.

5.11 Set substrate slide height

The substrate slide is placed after the compactor. The substrate slide has
the function to shift the excess of substrate off the tray.
Set the position of the substrate slide before you start working with
the machine.
Procedure:
1. Check the height of the substrate slide with respect to the tray.
The slide should be placed approximately 15mm above the tray.
2. If the height is incorrect:
a. Loosen wing nut (A).
b. Set the substrate slide to the desired height.
c. Tighten wing nut (A).

5.12 Set brush height

Set the brush height before you start working with the machine.
Procedure:
1. Check the height of the brush with respect to the tray. The slide
should be placed approximately 5mm above the tray. The brush is
intended to evenly level the substrate in the tray.
2. If the height is incorrect:
a. Loosen clamp (A).
b. Set the desired height using crank (B).
c. Tighten clamp(A).
Version 2016-2
User Manual Javo Matrix
B
A
A
B
A
15