Placing Format-Set Plates; Set Height Of Format-Sets; Check Rotation Direction - Javo Matrix User Manual

5.4 Placing format-set plates

For placing Format-sets, the machine fence can be
removed. The machine will stop automatically.
To rotate the carousel to the next position, use the 2-hand
control buttons.
Placing format-set plates is easy. The dowel pins on the
plates should be placed in the recesses.

5.5 Set height of format-sets

Check the height of the format-sets compared to the rotorbin and substrate slide before you start working
with the machine. When changing format-set plates, the height needs to be adjusted.
On the deposit place for format-set plates, the height of the set in relation to the substrate slide and rotorbin is
visible. If the plates are positioned too high, plates run against a sensor that will turn off circulating movement of the
machine.
In order to prevent that this sensor is turned on, set the format-set plates at the appropriate height in relation to the
substrate slide and rotorbin for every format-set plate. Use the handles above the format-set to set the correct
height.

5.6 Check rotation direction

Check the rotation direction of the elevator before you start working with
the machine.
Procedure:
1. Connect the power cable.
2. Start the elevator.
a. Turn on the main switch.
b. Press the reset button emergency stop circuit.
c. Start the elevator with the elevator button.
3. Check the direction of rotation of the elevator.
4. Stop the elevator by turning the filler off.
5. Turn off the main switch.
6. When rotation direction is incorrect:
a. Remove the plug from the socket.
b. Open the plug and switch 2 of the 3 phases in the plug. This should only be carried out by suitably
qualified personnel.
Version 2016-2
User Manual Javo Matrix
13