User Password; Micro Sd Card - Softing dataFEED Series User Manual

dataFEED Gateway - User Manual

6.5 User Password

The User Password view allows to change the dataFEED Gateway password(s) depending on the current role:
While a user logged-in as Administrator can change all individual dataFEED Gateway passwords, the user IT
Responsible only can modify the IT Responsible password and the user Service Engineer only can modify the
Service Engineer password.
Change Password - administrator
Change Password - itadmin
Change Password - mfadmin
Follow the steps to change the user password for the different user roles. The individual passwords, which can
be changed depend on the current role.
1. Enter the current password into the entry field of the Current Password section.
The entry of the current password is only required, if the password to be changed refers to the role of the
current user is logged-in to.
2. Enter the new password into the entry field of the New Password section.
3. Confirm the entered new password by re-typing the new password into entry field of the Confirm Password
section.
4. Click Save button to save the edited password changes.
Note
The new password is active immediately after clicking the Save button. Once the browser loads a
page that accesses dynamical data, a new login is required.
User roles and related tasks
Task
Modify configuration and update
firmware, change password of other
roles than Administrator
11
Modify IT Settings and
36
Settings
Modify Machine Settings
36
Settings
Note
Be careful when modifying the Administrator password.
If you forget the Administrator password, you can reset the device to factory settings (including the
Administrator password), however the configuration data will be lost by this step (see
8
button)

6.6 micro SD Card

The SD-Card view provides micro SD card related information and options.
SD Card Load
Shows, if a micro SD card is available and the percentage of the micro SD card memory used
The information not mounted indicates that the micro SD card is not recognized or available.
Click the Browse button in the SD-Card Content section to show the content of the micro SD card.
Click the Remove button in the Prepare save removal of SD-Card section to unmount the file system of the
micro SD card, so it can be safely removed from the dataFEED Gateway.
38
Administrator
(administrator)
Time
24
and Time
.
IT Responsible
(itadmin)
© Softing Industrial Automation GmbH
Service Engineer
(mfadmin)
Device reset