HP Elite Dragonfly Max Maintenance And Service Manual page 43

1. Disconnect the WWAN antenna cables (1) from the terminals on the WWAN module.
The number of antennas can vary.
2. Remove the Phillips M2.0 × 2.0 screw (2) that secures the WWAN module to the bottom cover. (The
WWAN module tilts up.)
3. Remove the WWAN module (3) by pulling the module away from the slot at an angle.
NOTE: When viewed with the antenna terminals at the top of the module, the white WWAN antenna
cables connects to the terminal to the left of the black WWAN antenna cables.
4. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
Component replacement procedures 35