Download Print this page
Deltran Battery Tender 022-0337 Manual

Deltran Battery Tender 022-0337 Manual

2amp/8amp 12volt selectable battery charger & maintainer

Advertisement

Quick Links

2Amp/8Amp 12Volt Selectable
Battery Charger & Maintainer
Designed for Six-Cell Lead-Acid/AGM/ Batteries
Four-Cell Lithium-Iron-Phosphate (LiFeP04)
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1)
important safety and operating instructions for battery charger model P/N 022-0337.
2)
Do not expose charger to rain or snow.
3)
Use of an attachment not recommended or sold by the battery charger manufacturer may
result in a risk of fire, electric shock, or injury to persons.
4)
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
5)
An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If an extension cord must
be used, make sure:
a)
That pins on plug of extension cord are the same number, size, and shape as those of
plug on charger;
b)
That extension cord is properly wired and in good electrical condition; and
c)
That wire size is large enough for ac ampere rating of charger as specified in Table 1
Length of Cord, Feet /Meters 25/7.6 50/15.2 100/30.5 150/45.6
AWG Size of Cord
6)
Do not operate charger with damaged cord or plug – replace the cord or plug
immediately.
7)
Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
8)
Do not disassemble charger; take it to a qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk of electric shock or fire.
9)
To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
10) WARNING – RISK OF EXPLOSIVE GASES.
a)
WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS.
BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY
OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU
FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.
b)
To reduce risk of battery explosion, follow these instructions and those published by
battery manufacturer and manufacturer of any equipment you intend to use in
vicinity of battery. Review cautionary marking on these products and on engine.
Deltran Battery Tender
and
Batteries
– This manual contains
TABLE 1
18
18
18
1
P/N 392-0700-R0

11) PERSONAL PRECAUTIONS
a)
Consider having someone close enough by to come to your aid when you work near
a lead-acid battery.
b)
Have plenty of fresh water and soap nearby in case battery acid contacts skin,
clothing, or eyes.
c)
Wear complete eye protection and clothing protection. Avoid touching eyes while
working near battery.
d)
If battery acid contacts skin or clothing, wash immediately with soap and water. If
acid enters eye, immediately flood eye with running cold water for at least 10
minutes and get medical attention immediately.
e)
NEVER smoke or allow a spark or flame in vicinity of battery or engine.
f)
Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark
or short-circuit battery or other electrical part that may cause explosion.
g)
Remove personal metal items such as rings, bracelets, necklaces, and watches
when working with a lead-acid battery. A lead-acid battery can produce a short-
circuit current high enough to weld a ring or the like to metal, causing a severe burn.
h)
Use charger for charging a LEAD-ACID battery only. It is not intended to supply
power to a low voltage electrical system other than in a starter-motor application. Do
not use battery charger for charging dry-cell batteries that are commonly used with
home appliances. These batteries may burst and cause injury to persons and
damage to property.
i)
NEVER charge a frozen battery.
12) PREPARING TO CHARGE
a)
If necessary to remove battery from vehicle to charge, always remove grounded
terminal from battery first. Make sure all accessories in the vehicle are off, so as not
to cause an arc.
b)
Be sure area around battery is well ventilated while battery is being charged.
c)
Clean battery terminals. Be careful to keep corrosion from coming in contact with
eyes.
d)
Add distilled water in each cell until battery acid reaches level specified by battery
manufacturer. Do not overfill. For a battery without removable cell caps, such as
valve regulated lead acid batteries, carefully follow manufacturer's recharging
instructions.
e)
Study all battery manufacturers specific precautions such as removing or not
removing cell caps while charging and recommended rates of charge.
16
f)
Determine voltage of battery by referring to car owner's manual and make sure that
output voltage selector switch is set at correct voltage. Do not use the battery
charger unless battery voltage matches the output voltage rating of the charger.
13) CHARGER LOCATION
a)
Locate charger as far away from battery as dc cables permit.
b)
Never place charger directly above battery being charged; gases from battery will
corrode and damage charger.
c)
Never allow battery acid to drip on charger when reading electrolyte specific gravity
or filling battery.
d)
Do not operate charger in a closed-in area or restrict ventilation in any way.
e)
Do not set a battery on top of charger.
14) DC CONNECTION PRECAUTIONS
a)
Connect and disconnect dc output clips only after setting any charger switches to
offposition and removing ac cord from electric outlet. Never allow clips to touch
each other.
b)
Attach clips to battery and chassis as indicated in 15(e), 15(f), and 16(b) through
16(d).
2

Advertisement

loading
Need help?

Need help?

Do you have a question about the Battery Tender 022-0337 and is the answer not in the manual?

Questions and answers

Summary of Contents for Deltran Battery Tender 022-0337

  • Page 1 Deltran Battery Tender  11) PERSONAL PRECAUTIONS 2Amp/8Amp 12Volt Selectable Consider having someone close enough by to come to your aid when you work near a lead-acid battery. Battery Charger & Maintainer Have plenty of fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes.
  • Page 2 USER INSTRUCTIONS 15) FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE. A SPARK NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY: Position ac and dc cords to reduce risk of damage by hood, door, or moving engine part.
  • Page 3 BATTERY TYPE SELECTION BUTTON AUTOMATIC CHARGING AND BATTERY STATUS MONITORING: Battery Tender® battery chargers are completely automatic and may be left ® The Battery Tender battery charger has a “Battery Type selection button connected to both AC power and to the battery that it is charging for long which allows you to switch between charging a 12 Volt Standard (Lead periods of time.
  • Page 4: Troubleshooting

    WORKING WITH A DEAD BATTERY OR A BATTERY WITH A VERY LOW VOLTAGE:  Charging Status/Error LED Ring FLASHING Green – When the If you try to charge a dead battery having a voltage below 3 volts, the Light Ring is Flashing green the battery is greater than 80% Battery Tender ®...
  • Page 5 FCC Warning Title 47 Subpart, 15.105(b) Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation.