Deltran Battery Tender Instructions Manual

Deltran Battery Tender Instructions Manual

12volt / 6volt 3.5amp selectable battery charger & maintainer
Hide thumbs Also See for Battery Tender:
Table of Contents
  • Instructions Importantes Concernant la Sécurité
  • Guide de L'utilisateur
  • Dépannage
  • Avertissement de la FCC

Advertisement

Available languages

Available languages

12Volt / 6Volt 3.5Amp Selectable
Battery Charger & Maintainer
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1)
important safety and operating instructions for battery charger model P/N 022-0336.
2)
Do not expose charger to rain or snow.
3)
Use of an attachment not recommended or sold by the battery charger manufacturer may
result in a risk of fire, electric shock, or injury to persons.
4)
To reduce risk of damage to electric plug and cord, pull by plug rather than cord when
disconnecting charger.
5)
An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result in a risk of fire and electric shock. If an extension cord must
be used, make sure:
a)
That pins on plug of extension cord are the same number, size, and shape as those of
plug on charger;
b)
That extension cord is properly wired and in good electrical condition; and
c)
That wire size is large enough for ac ampere rating of charger as specified in Table 1
Length of Cord, Feet /Meters 25/7.6 50/15.2 100/30.5 150/45.6
AWG Size of Cord
6)
Do not operate charger with damaged cord or plug – replace the cord or plug
immediately.
7)
Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman.
8)
Do not disassemble charger; take it to a qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk of electric shock or fire.
9)
To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
10) WARNING – RISK OF EXPLOSIVE GASES.
a)
WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS.
BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY
OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOU
FOLLOW THE INSTRUCTIONS EACH TIME YOU USE THE CHARGER.
b)
To reduce risk of battery explosion, follow these instructions and those published by
battery manufacturer and manufacturer of any equipment you intend to use in
vicinity of battery. Review cautionary marking on these products and on engine.
11) PERSONAL PRECAUTIONS
a)
Consider having someone close enough by to come to your aid when you work near
a lead-acid battery.
b)
Have plenty of fresh water and soap nearby in case battery acid contacts skin,
clothing, or eyes.
c)
Wear complete eye protection and clothing protection. Avoid touching eyes while
working near battery.
Deltran Battery Tender
Designed for six-cell lead-acid batteries
and three-cell lead-acid batteries
– This manual contains
TABLE 1
18
18
18
1
P/N 392-0427-RA

d)
If battery acid contacts skin or clothing, wash immediately with soap and water. If
acid enters eye, immediately flood eye with running cold water for at least 10
minutes and get medical attention immediately.
e)
NEVER smoke or allow a spark or flame in vicinity of battery or engine.
f)
Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark
or short-circuit battery or other electrical part that may cause explosion.
g)
Remove personal metal items such as rings, bracelets, necklaces, and watches
when working with a lead-acid battery. A lead-acid battery can produce a short-
circuit current high enough to weld a ring or the like to metal, causing a severe burn.
h)
Use charger for charging a LEAD-ACID battery only. It is not intended to supply
power to a low voltage electrical system other than in a starter-motor application. Do
not use battery charger for charging dry-cell batteries that are commonly used with
home appliances. These batteries may burst and cause injury to persons and
damage to property.
i)
NEVER charge a frozen battery.
12) PREPARING TO CHARGE
a)
If necessary to remove battery from vehicle to charge, always remove grounded
terminal from battery first. Make sure all accessories in the vehicle are off, so as not
to cause an arc.
b)
Be sure area around battery is well ventilated while battery is being charged.
c)
Clean battery terminals. Be careful to keep corrosion from coming in contact with
eyes.
d)
Add distilled water in each cell until battery acid reaches level specified by battery
manufacturer. Do not overfill. For a battery without removable cell caps, such as
valve regulated lead acid batteries, carefully follow manufacturer's recharging
instructions.
e)
Study all battery manufacturers specific precautions such as removing or not
removing cell caps while charging and recommended rates of charge.
f)
Determine voltage of battery by referring to car owner's manual and make sure that
output voltage selector switch is set at correct voltage. Do not use the battery
charger unless battery voltage matches the output voltage rating of the charger.
16
13) CHARGER LOCATION
a)
Locate charger as far away from battery as dc cables permit.
b)
Never place charger directly above battery being charged; gases from battery will
corrode and damage charger.
c)
Never allow battery acid to drip on charger when reading electrolyte specific gravity
or filling battery.
d)
Do not operate charger in a closed-in area or restrict ventilation in any way.
e)
Do not set a battery on top of charger.
14) DC CONNECTION PRECAUTIONS
a)
Connect and disconnect dc output clips only after setting any charger switches to
offposition and removing ac cord from electric outlet. Never allow clips to touch
each other.
b)
Attach clips to battery and chassis as indicated in 15(e), 15(f), and 16(b) through
16(d).
15) FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN VEHICLE. A SPARK
NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A
SPARK NEAR BATTERY:
a)
Position ac and dc cords to reduce risk of damage by hood, door, or moving engine
part.
b)
Stay clear of fan blades, belts, pulleys, and other parts that can cause injury to
persons.
c)
Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has
larger diameter than NEGATIVE (NEG, N,–) post.
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Battery Tender and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Deltran Battery Tender

  • Page 1 Deltran Battery Tender  If battery acid contacts skin or clothing, wash immediately with soap and water. If 12Volt / 6Volt 3.5Amp Selectable acid enters eye, immediately flood eye with running cold water for at least 10 minutes and get medical attention immediately.
  • Page 2 USER INSTRUCTIONS Determine which post of battery is grounded (connected) to the chassis. If negative post is grounded to chassis (as in most vehicles), see (e). If positive post is grounded to the chassis, see (f). For negative-grounded vehicle, connect POSITIVE (RED) clip from battery charger to POSITIVE (POS, P, +) ungrounded post of battery first.
  • Page 3 CHARGER HAS A SPARK FREE AUTOMATIC CHARGING AND BATTERY STATUS MONITORING: CIRCUITRY. The output alligator clips or ring terminals will not spark when Battery Tender® battery chargers are completely automatic and may be left ® they are touched together. The Battery Tender...
  • Page 4: Troubleshooting

    If you try to charge a dead battery having a voltage below 3 volts, the If the charger does not turn on and none of the LEDs illuminate. Battery Tender ® charger will not start. An internal safety circuit prevents the...
  • Page 5: Instructions Importantes Concernant La Sécurité

    Pour réduire les risques de choc électrique, déconnectez le chargeur de la prise avant tout entretien ou nettoyage. La désactivation des commandes ne Battery Tender® Deltran réduira pas ce risque. 10) AVERTISSEMENT – RISQUE DE GAZ EXPLOSIFS. Chargeur et mainteneur de TRAVAILLER À...
  • Page 6 Ajoutez de l'eau distillée dans chaque élément jusqu'à ce que le niveau conduites de carburant, ou aux pièces de la carrosserie en tôle. d'acide de la batterie atteigne le niveau spécifié par le fabricant de la Connectez à une pièce métallique de forte épaisseur du châssis ou du batterie.
  • Page 7: Guide De L'utilisateur

    GUIDE DE L' UTILISATEUR     CHARGE ET SURVEILLANCE AUTOMATIQUES DE L'ÉTAT DE LA Les chargeurs de batteries Battery Tender® sont BATTERIE : entièrement automatiques et peuvent être laissés branchés sur une alimentation en c.a. et à la batterie en cours de charge pendant de longues périodes.
  • Page 8 à pleine TEMPS NÉCESSAIRE POUR CHARGER UNE BATTERIE : charge. Ce chargeur de batteries Battery Tender® charge à un taux de 3,5 ampères ampères-heure heure. BOUTON DE SÉLECTION DE TENSION DE LA BATTERIE conséquent, la recharge à 80 % de sa capacité d'une batterie ®...
  • Page 9: Dépannage

    VOYANTS DEL ET ANNEAU LUMINEUX D’INDICATION DÉPANNAGE D’ÉTAT : Si les voyants ne s'allument pas, cela signifie que la batterie n'est pas connectée correctement et/ou 1) Si le chargeur ne se met pas en marche et aucun que le chargeur n'est pas branché sur l’alimentation c.a. voyant DEL ne s'allume.
  • Page 10: Avertissement De La Fcc

    Avertissement de la FCC Titre 47, sous-partie, 15.105(b) Remarque : Cet équipement a été testé et a été jugé conforme aux limites établies pour un dispositif numérique de classe B, conformément à la section 15 de la réglementation FCC. Ces limites sont conçues pour apporter une protection raisonnable contre les interférences nuisibles dans le cadre d'une installation domestique.

This manual is also suitable for:

022-0336-rot

Table of Contents

Save PDF