Advertisement
Quick Links
Knockonwood DBE KNUF
Mounting instructions
L
21
12
*
230VAC
8.5
15
16
• use the supplied adapter. A 12V DC supply can be used
•
standard connection right
Install the unit with the connecting side toward the inside of the room.
Hydraulic connections to the LHS:
230VAC*
Standard to the RHS
Deze handleiding is beschikbaar in het NEDERLANDS: http://theradiatorfactory.com/KNUF_benl
Ce manuel est disponible en FRANÇAIS: http://theradiatorfactory.com/KNUF_fr
Dieses Handbuch ist erhältlich in DEUTSCH: http://theradiatorfactory.com/KNUF_de
This manual is available in ENGLISH: http://theradiatorfactory.com/KNUF_e
15
9.5
OK!
3.8
14
Aansluiten
R
180°
2
3
1
Hydraulic connections to the left:
Rotate the feet 180°
21
*
230VAC
6
• push the bottom of the flap to enter the valve
The temperature sensor must extend 2 cm
below the unit
OK!
L
2
3
1
E - 27200.23101001- 22 February 2017 3:53 PM - Jaga N.V.
± 2 cm
Temp. sensor
230VAC*
Advertisement
Related Manuals for Jaga Knockonwood DBE KNUF
Summary of Contents for Jaga Knockonwood DBE KNUF
- Page 1 Deze handleiding is beschikbaar in het NEDERLANDS: http://theradiatorfactory.com/KNUF_benl Ce manuel est disponible en FRANÇAIS: http://theradiatorfactory.com/KNUF_fr Dieses Handbuch ist erhältlich in DEUTSCH: http://theradiatorfactory.com/KNUF_de This manual is available in ENGLISH: http://theradiatorfactory.com/KNUF_e E - 27200.23101001- 22 February 2017 3:53 PM - Jaga N.V.
- Page 2 Degrease the surface for mounting of the Install the control panel with the tape fac- Control Panel. Stick the Control Panel, ing the inside of the room press 10 seconds. E - 27200.23101001- 22 February 2017 3:53 PM - Jaga N.V.
- Page 3 • clean the casing with a soft cloth dampened with water and a little dish soap. Do not use products based on solvents and detergents.The wooden casing may be treated with a neutral cleaner. Jaga recommends using the supplied cleaner „Proterra GR 1900“: more info, see www.hesse-lignal.de.
- Page 4 • make sure that there are no water leaks. Drain cock, air vent and Modification, change or alteration of the unit, except as expressly valve are tightened up in the Jaga factory by hand. While filling the directed in writing by Jaga n.v. Also, the risk analysis should be com- installation, control on leaks.