Checking And Adding Other Service Products; Adding Engine Oil; Checking The Coolant Level - Mercedes-Benz A-Class Series Owner's Manual

Table of Contents

Advertisement

If the
Engine oil level not when
engine on
message appears:
Switch off the engine.
X
If the engine is at normal operating tem-
X
perature: wait about five minutes before
carrying out the measurement.
If the engine is not at normal operating
temperature, e.g. if the engine was only
started briefly: wait about 30 minutes
before carrying out the measurement.
i
If you wish to cancel the measurement,
press the * or & button on the steer-
ing wheel.

Adding engine oil

H
Environmental note
When topping up the oil, take care not to spill
any. If oil enters the soil or waterways, it is
harmful to the environment.
G
Risk of fire and injury
If engine oil comes into contact with hot
engine parts, it may ignite and you could burn
yourself. Do not spill any engine oil on hot
engine parts.
Example: engine oil cap
Turn cap : anti-clockwise and remove it.
X
Top up with the amount of oil required.
X
Observe the specifications in the on-board
computer when doing so or fill carefully to the
maximum mark on the oil dipstick.
Engine compartment
i
The difference between the minimum
mark and the maximum mark on the oil
dipstick is approximately 1.2 litres.
! Do not add too much oil. If the oil level is
above the "max" mark on the dipstick, too
much oil has been added. This can lead to
damage to the engine or the catalytic con-
verter. Have excess oil siphoned off.
Further information on engine oil
(
page 256).
Y
Replace cap : on the filler neck and
X
tighten clockwise.
Ensure that the cap locks into place
securely.
Checking and adding other service
products

Checking the coolant level

Only check the coolant level when the vehicle
is on a level surface and the engine has cooled
down.
Turn the key to position 2(
X
the ignition lock.
Check the coolant temperature display in
X
the instrument cluster.
G
Risk of injury
The cooling system is pressurised. Therefore,
only unscrew the cap once the engine has
cooled down. The coolant temperature gauge
must display less than 70 † . Otherwise, you
could be scalded if hot coolant escapes.
211
page 111) in
Y
Z

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

A 160A 160 36A 160 cdiA 160 cdi 36A 180A 180 36 ... Show all

Table of Contents