Using The Setup Wizard - SonicWALL SuperMassive 9800 Getting Started Manual

Hide thumbs Also See for SuperMassive 9800:

Table of Contents

• Green indicates 100 Mbps

• An unlit left LED with the right LED lit indicates 10 Mbps

Using the Setup Wizard

When you are ready to begin initial setup, configure your

management computer with a static IP address on the

192.168.168.0/24 subnet, such as 192.168.168.20.

This allows your computer to connect to SonicOS via the

MGMT interface.

NOTE: Be sure to disable pop‐up blocking software, or

set your Web browser to allow pop‐ups and cookies.

To configure initial settings using the Setup Wizard:

1 With your computer connected to the appliance MGMT

port, start your Web browser and navigate to the

default MGMT interface IP address:

http://192.168.168.168.

The initial screen displays the options to launch the

Setup Wizard or configure the appliance manually.

2 Launch the SonicWall Setup Wizard by clicking the first

here link. This wizard helps you quickly configure the

SonicWall appliance to secure your Internet

connection.

3 Follow the on‐screen prompts to complete the admin

password and network settings.

If a DHCP server is available on the network, the wizard

requests IP settings from it. You can click Next to accept

these or click Manual Config to enter a static IP address

and other network settings.

In the Manual Configuration page, click Retry to revert

to DHCP, or enter your own settings, and then click

Next.

SonicWall SuperMassive 9800 Getting Started Guide

Table of Contents