Table of Contents
Advertisement
6.
Connect the proper electric supply to the motor and/or motor controller, following
the interwiring diagram supplied with this manual. The AC or DC motor controller (if
present) must be grounded to minimize noise to the electronic integrator. Refer to
the applicable wiring diagram to make all electrical connections between the
electronic integrator and the weighfeeder.
7.
Remove only the TAGGED shipping bolt or bracket that is attached to the dual beam
load cell types only. This bolt supports the weighbridge during transport and
installation.
DO NOT loosen or tighten the overload bolt (on dual beam loadcells) — it has
Note:
been factory set to minimize the possibility of load cell damage resulting from
incidental overload.
8.
Before starting the machine, make a final check to see that the conveyor belt is free
of all tools and foreign objects.
Page 8
SITRANS WW300 - OPERATING INSTRUCTIONS
7ML19985MQ01
Advertisement
Table of Contents
