Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
Description (Figure 2)
A. Hydraulic Brake Assembly (Not Shown)..... 1
B. Brake Handle .............................................. 1
C. Brackets ...................................................... 4
D. Flat Washers 10mm (Brackets) .................. 8
E. Cap Screws M10-1.5 x 20 (Brackets) ......... 8
F.
Hex Wrench 8mm ....................................... 1
G. Rubber Feet M10-1.5 x 55 .......................... 4
H. Flat Washers 10mm (Mounting) ................. 4
I.
Hex Nuts M10-1.5 (Mounting) ..................... 8
J.
Hex Bolts M10-1.5 x 30 (Mounting) ............ 4
B
C
D
E
F
Figure 2. Loose parts inventory.
Assembly
1.
Attach brackets to brake assembly base at
each corner with (2) M10-1.5 x 20 cap screws
and (2) 10mm flat washers (see Figure 3).
Base
Bracket
(1 of 4)
Figure 3. Bracket attached to base.
-2-
Qty
G
H
I
J
x 2
2.
Insert brake handle (see Figure 4) into
receiver on hydraulic ram.
Receiver
Figure 4. Brake handle installed in receiver on
hydraulic ram.
Mounting with Rubber Feet
Tools Needed
Wrench or Socket 17mm ................................... 2
To mount with rubber feet:
1.
Attach a rubber foot to each base corner with
(1) 10mm flat washer and (2) M10-1.5 hex
nuts (see Figure 7).
x 4
Figure 7. Base mounted with feet.
Model T28930 (Mfd. Since 12/18)
Brake Handle
Qty
Advertisement
