Technical Data - Parkside PAK 20-Li B2 Translation Of The Original Instructions

GB IE

Technical data

Cordless air pump ................PALP 20-Li B2
Nominal voltage U ..................... 20 V
Air volume ................................ 70 m
Sound pressure level
(L ) ................. 72.27 dB(A), K
pA
Sound power level (L
measured ........ 83.27 dB(A), K
Vibration (a ) ........1.63 m/s
h
Cordless compressor ..............PAK 20-Li B2
Nominal voltage U ...................... 20 V
Max. operating pressure 0.70 MPa (7 bar)
Sound pressure level
(L ) ................... 75.2 dB(A), K
pA
Sound power level (L
measured ..... 85.3 dB(A), K
Vibration (a ) .......1.75 m/s
h
Attention! An up-to-date list
of battery compatibility can
be found at:
www.lidl.de/akku
This device can only be operated with the
following rechargeable batteries:
PAP 20 A1, PAP 20 A2, PAP 20 A3.
This type of battery may be charged
with the following chargers: PLG 20 A1,
PLG 20 A3, PDSLG 20 A1.
Battery (Li-Ion) ...............PAP 20 A1
Battery cells ......................................... 5
Nominal voltage ......................... 20 V
Capacity ..................................... 2.0 Ah
Energy ..................................... 40 Wh
Charging time ...................... approx. 1 h
Temperature...........................max. 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
22
= 3 dB
pA
)
WA
= 3 dB
WA
2 , K= 1.5 m/s
= 3 dB
pA
)
WA
= 2.47 dB
WA
2 , K= 1.5 m/s
Charger .............................. PLG 20 A1
Nominal consumption .....................65 W
Voltage input ............ 230-240 V~, 50 Hz
Voltage output ......................... 21.5 V
3 /h Voltage current .............................. 2.4 A
Safety class ......................................
Miniature fuse ............................. T3.15A
Attention! This charger can only
recharge the following batteries:
PAP 20 A1, PAP 20 A2, PAP 20 A3.
Levels of noise and vibration were deter-
mined according to the standards and re-
gulations in the declaration of conformity.
The specifi ed total vibration value and the
stated noise emission value have been
2 measured according to a standardised test
method and can be used to compare one
power tool with another.
The specifi ed total vibration value and the
stated specifi ed noise emission value can
also be used for a provisional assessment
of the load.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).
II