Using The Led Light; Using The Jump Leads; Connecting; Starting - ULTIMATE SPEED DIS-159 Operation And Safety Notes

position. With automatic gearboxes put the
gear selector into „P".
Position the jump leads in such a manner that
they cannot be caught up in the moving parts
of the engine.

Using the LED light

In poor lighting conditions, the LED lights
make connecting the jump leads easy.
To switch on the LED light
switch to (I). To switch off the LED light
5
set the ON/OFF switch
Two button cell batteries are located in each
terminal. To replace these, remove the screws
which are affixed directly to the ON/OFF
switch and remove the plastic cover.
5
Please note the polarity when inserting the
batteries (plus and minus poles).

Using the jump leads

Connecting

EXPLOSION HAZARD! On no
account should you connect the
negative pole terminal (-) to the flat
battery as there is a risk that sparks may fly
and ignite explosive gases.
1. Connect the red jump lead
pole terminal (+)
1a
flat battery (A) an.
2. Connect the other pole terminal
jump lead to the positive pole of the donor
1
battery (B).
3. Connect the black jump lead
pole terminal (–)
2a
the donor battery (B).
4. Then connect the other pole terminal
black jump lead
2
on the earthing strap or another unpainted
part on the engine block of the broken-down
vehicle (A).
Safety Information / Using the LED light / Using the jump leads
4
set the ON/OFF
4
to (0).
5
with the red
1
to the positive pole on the
of the red
1b
with the black
2
to the negative pole of
of the
2b
to the vehicle chassis, e.g.
Note: The parts should be as far away as possi-
ble from the starter battery in order to prevent any
explosive gas that may develop from being ignited.
Note: If the green LED of the overvoltage protection
lights up, it means that this has been activated
3
and is functioning. The overvoltage protection ab-
sorbs any potential voltage peaks.

Starting

After you have connected the jump leads, first
4
switch on the engine of the vehicle with the
donor battery and bring it to average speed
(car B). Then start the engine of the broken-down
vehicle (car A).
Note: After every attempt to start the car - which
should not be longer than 15 seconds - wait for
at least 1 minute. If you cannot start the car after
several attempts, contact a garage.
A fter successfully starting the broken-down
vehicle (car A) wait for 2 to 3 minutes until the
engine is running smoothly.

Disconnecting

Note: Disconnect the jump leads in the reverse
order to the way they were connected.
1. Remove the pole terminal
lead from the earth strap of the broken-
2
down car (A).
2. Then disconnect the other pole terminal
the black jump lead
of the donor battery (B).
3. Remove the two pole terminals
the red jump lead
(A, B).
When removing the jump leads, make sure that
they do not come into contact with the moving
parts of the engine.
of the black jump
2b
2a
from the negative pole
2
and
1a 1b
in any order you wish
1
GB/IE
of
of
17