Table Of Contents - Claas QUADRANT 2200 Repair Manual

1 GENERAL NOTES
INTRODUCTION .........................
INTRODUCTION TO THE
CLAAS REPAIR HANDBOOK ..............
EXPLANATION OF GRAPHIC SYM BOLS ...
GENERAL NOTES ON REPAIR ............
TORQUE SPECIFICATIONS
Tightening torque (in Nm) for
hex agonal bolts, cylinder head bolts
and hex agonal nuts . . . . . . . . . . . . . . . . . . . . . . . 1 .4 / 1
Torque specifications for
hydraulic connections with O-ring seals
complying with ISO 6149 . . . . . . . . . . . . . . . . . . 1.4 / 2
SPECIFICATIONS
Oil quantities . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.5 / 1
BASIC SETTINGS FOR THE DRIVES
Adjusting the drives to the markings ........ 1.6 / 1
BASIC SETTINGS FOR THE
TWINE WRAP DEVICE ......................... .
Setting up the knotter shaft and needles . . . . . 1 . 7 / 1
Checking the setting of the needles
to the piston . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 7 / 4
Opportunities for control checks
in the bale chamber ....................... 1.7 / 5
Needle yoke brake . . . . . . . . . . . . . . . . . . . . . . . 1. 7 / 6
Kn otter shaft brake . . . . . . . . . . . . . . . . . . . . . . . 1 . 7 / 6
Adjusting the springs for
the clamping plates . . . . . . . . . . . . . . . . . . . . . . . 1 . 7 / 7
Adjusting the springs for
the kn otter hooks . . . . . . . . . . . . . . . . . . . . . . . . . 1 . 7 / 7
Setting up the play on
the knotter pinion . . . . . . . . . . . . . . . . . . . . . . . . . 1. 7 / 7
Twine finger ............................. 1.7 / 8
Ram stop ............................... 1.7 / 9
Find manuals at http://best-manuals.com/search?&s=CLA-2981710
1.1 / 1
1.1 / 1
1.2 / 1
1.3 / 1