3
A
23408
BASIC SETTINGS FOR THE TWINE WRAP
DEVICE
Setting up the knotter shaft and needles
PLEASE NOTE! All settings for the knotter should be
made without baler twine threaded into the machine.
Setting the lateral stops of the needles on the knotter
frame:
Set up the needles ( 1) on the needle brackets, align
to the centre of the needle slot and screw tight.
The bolt torque of the hex agonal bolts ( 2)
M 10 = 45 Nm
Trigger the tying cycle using the control terminal, or
mechanically by pushing forward the cam (N) at the
control lever (S) .
(Fig. 1 and 2)
QUADRANT 2 2 00 / 2 2 00 RC
Basic settings for the twine wrap device
3
1
1
1.7 / 1