Opportunities For Control Checks - Claas QUADRANT 2200 Repair Manual

Opportunities for control checks in the bale
chamber
When set up correctly, the points of the needles lie
at the upper edge of the filler piece (F) in the bale
chamber.
The distance (X) to the side wall of the piston is then
3 0 to 5 0 mm, see detail (Y) .
(Fig. 6 )
Note: This control point can be viewed from the
lower front, in the twine box es through the hole
provided (B), see detail (Y) .
If necessary, correct this by resetting the articulated
shaft of the knotter shaft drive.
Correcting the setting:
Release the tying cycle.
Turn the piston towards the rear by turning the
flywheel by hand (in the direction of the arrow) , until
the markings (M ) on the needles are at point ( 11) at
the level of the guide (A) .
Lock the knotter drive shaft by pushing a mandrel into
the interlock between the cogwheels. Then remove
the articulated shaft.
Turn the piston towards the rear by turning the
flywheel by hand (in the direction of the arrow) until
the red gauge (L) on the baling ram on the left side of
the machine is situated between the brace (S) and
the bar (H) . Refit the articulated shaft.
As a check, carry out one tying cycle and one piston
stroke.
(Fig. 6 to 9)
QUADRANT 2200 / 2200 RC
Basic settings for the twine wrap device
1.7 / 5