Basic settings for the twine wrap device
y
200740
6
Checking the setting of the needles to the piston
Release the tying cycle.
Turn the piston towards the rear by turning the
flywheel by hand (in the direction of the arrow) until
the red gauge (L) on the baling ram on the left side of
the machine is situated between the brace (S) and
the bar (H) .
The markings (M ) on the needles must then be at
point ( 11) at the level of the guide (A) .
(Fig. 6 , 7 and 8)
7
1.7 / 4
QUADRANT 2 2 00 / 2 2 00 RC