Twine Finger - Claas QUADRANT 2200 Repair Manual

Basic settings for the twine wrap device
22879
1 7
1.7 / 8

Twine finger

The twine fingers ( 1) are controlled by means of
the rod linkages ( 2) . They press the baler twine tightly
against the twine guides ( 3) when the needles move
forward, so that the knotter hooks are sure to capture
the twine.
Setting the twine fingers:
The rod linkages ( 2) must be set up so that the
distance from the centre of the ball head, dimension
(B), is about 2 00 mm.
With twine fingers ( 1) at the end position, the point
must lie on the knotter plate ( 4) . If necessary,
compensate for the ax ial play in the twine finger
at (C) using shims.
In this position the distance from the twine fingers ( 1)
to the tip of the twine guide ( 3), dimension (A) , must
be 0± 1 mm.
If necessary, correct the setting by adjusting the rod
linkages ( 2) .
(Fig. 17)
QUADRANT 2 2 00 / 2 2 00 RC