Table of Contents
Advertisement
1
SAFETY
1.1
Safety information
The statements contained in this document only apply to the maintenance of the stated gas
springs and are only for the use by trained and authorised staff.
Staff has to have the necessary training, experience and product knowledge as well as specialist
tools in order to carry out maintenance work correctly.
Staff has to have fully read and understood this document prior to carrying out any maintenance
work.
Replacement of spare parts without special training or knowledge of the maintenance instruc-
tions and without the specialist tools can be dangerous and may lead to accidents causing se-
vere injuries or even death.
Most accidents during maintenance occur due to disregarding the basic safety regulation.
Noticing a potential danger can prevent accidents from happening. Safety information in this
document warn about potential risks. FIBRO GMBH can not foresee all situations which may
potentially cause risks. The warnings in this document are therefore not all encompassing.
If a work material, an act, a work method or work technique is used which has not been specif-
ically suggested by FIBRO GMBH, then the user has to ensure the safety for himself and other
persons.
The information, descriptions and illustrations in this documents are based on the information
on the basis of information which was available at the point of creation of this document.
Illustrations show examples of a potential gas spring and are not to scale.
Descriptions, tightening torques, operating pressures, measuring methods, illustrations and oth-
er points are subject to change at any time. The changes can have an influence on the compo-
nent's properties. Prior to starting any work, obtain the currently available information.
4/30
Maintenance instructions Gas spring DS
Safety
Advertisement
Table of Contents
