Table of Contents
Advertisement
Maintenance
20. Screw the T-lever into the piston rod.
21. Pull out the piston rod and the guide using the T-lever. Pull the T-lever until the guide is flush
22. Close the service port with the locking screw.
23. Screw the valve with the valve tool into the fill opening.
24. Fill the gas spring with gas (see chapter 2.4 "Fill with nitrogen" on page 24).
25. Mount the dirt ring guard. The dirt ring guard must be in contact with the circlip!
26. Screw in the G1/8" locking screw.
27. Fit a new warning tape over the service port.
28. Remove the old sticker from the cylinder pipe.
29. Affix the supplied sticker onto the cylinder pipe and enter the nominal travel onto the sticker.
Maintenance instructions Gas spring DS
with the end of the cylinder pipe.
23/30
Advertisement
Table of Contents
