Audi R8 LMS 2018 Handbook page 85

Minimum ride height (see chapter 800 - 1.1 Homologation)
-
Measured on the floor beneath the axles:
-
Measure on the FIA reference points on the
chassis:
Rear wing position (see chapter 800 - 1.1 Homologation)
Ensure that the Gurney flap – uppermost edge of the rear wing – is within the
homologated dimension at all times!
The position of the Gurney can be checked by using the rear wing jig V03 862
704 CB TEMPLATE REAR WING. If the rear wing is not in the window, the wing
supports must be tilted forwards or backwards in X around the lower mounting
point.
Version 1 2016-01-01
801- Aerodynamics
Front Rear
54 mm 54 mm
65.5 mm 128 mm
85 / 113