Commissioning; Adjustments - Festool OF 2200 EB Operating Manual

- Do not clamp tools with an unsuitable shank
diameter in the clamping collet.
- Wear suitable protection such as ear protection,
safety goggles, a dust mask for work which gen-
erates dust, and protective gloves when working
with raw materials and when changing tools.
- Festool electric power tools should only be in-
stalled in work benches specially designed by
Festool. The electric power tool may become
unsafe and cause serious accident if installed
in benches from other manufacturers or self-
manufactured work benches.
5.3 Emission levels
Noise levels are measured in accordance with EN
60745:
Sound pressure level
Noise level
Uncertainty
CAUTION
The noise produced during work can damage
your hearing.
fAlways use ear protection.
Overall vibration levels (vector sum for three di-
rections) measured in accordance with EN 60745:
Vibration emission level
(3-axis)
Uncertainty
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
6

Commissioning

WARNING
Risk of accident if the machine is operated us-
ing unauthorised voltages or frequencies.
fThe mains voltage and the frequency of the
power source must correspond with the spec-
ifications on the machine's name plate.
The switch [2.2] is an on/off switch. Press the side
locking knob [2.1] to lock the switch for continu-
ous operation. Press the switch again to release
the knob.
7
Risk of accident, electric shock
fAlways pull the plug out of the socket before
7.1 Electronics
The OF 2200 EB features full-wave electronics
with the following properties:
Smooth start-up
L = 87 dB(A)
PA
The electronically controlled smooth start-up
L = 98 dB(A)
WA
function ensures that the machine starts up
K = 3 dB
smoothly.
Speed control
You can regulate the rotational speed steplessly
between 10000 and 22000 rpm using the adjust-
ing wheel [1.11]. This enables you to optimise the
cutting speed to suit the respective material and
routing tool:
a < 2,5 m/s 2
h
K = 1,5 m/s²
Material
Hardwood
Softwood
Chipboard,
coated
Plastic
Aluminium
Plasterboard
Constant speed
The preselected motor speed remains constant
through electronic control. This ensures a uni-
form cutting speed even when under strain.

Adjustments

WARNING
performing any type of work on the machine.
Routing tool diameter
10 -30 30 - 50 50 - 89
Adjusting wheel setting
6 - 4
6 - 5
6 - 5
6 - 4
3 - 1
2 - 1
OF 2200 EB
[mm]
HW
5 - 3 3 - 1
(HSS)
HSS
6 - 4 5 - 3
(HW)
6 - 4 4 - 2 HW
HW
6 - 3 3 - 1
HSS
3 - 1 2 - 1
(HW)
HW
1 1
19