Do you have a question about the BX2660 and is the answer not in the manual?
Questions and answers
Chester Buck
May 22, 2025
what is the service for a injection pump, oil level and type of oil, draining and refilling with new oil, it has a oil fill cap
1 comments:
Mr. Anderson
May 25, 2025
For the Kubota BX2660:
Injection Pump Service Procedure: - Fuel passes through a filter to remove impurities (dirt, water, etc.). - It then enters the injection pump, where it is pressurized to 13.7–14.7 MPa (1990–2133 psi). - The pressurized fuel is injected into the combustion chamber through the injection nozzle. - Some fuel lubricates the nozzle’s needle valve and returns to the tank via the fuel overflow pipe.
Oil Level Check and Refill Procedure: 1. Place an oil pan under the tractor. 2. Remove the drain plug at the bottom of the transmission case and drain the oil. 3. Reinstall the drain plug. 4. Remove the filling plug and fill new oil up to the upper notch on the dipstick. 5. Run the engine for a few minutes, stop it, and recheck the oil level. Add oil if needed.
Type of Oil: - Use only multi-grade transmission oil. - Do not mix different brands of oil.
Transmission Fluid Capacity: - 11.6 liters (3.1 U.S. gallons or 2.6 Imperial gallons).
Need help?
Do you have a question about the BX2660 and is the answer not in the manual?
Questions and answers
what is the service for a injection pump, oil level and type of oil, draining and refilling with new oil, it has a oil fill cap
For the Kubota BX2660:
Injection Pump Service Procedure:
- Fuel passes through a filter to remove impurities (dirt, water, etc.).
- It then enters the injection pump, where it is pressurized to 13.7–14.7 MPa (1990–2133 psi).
- The pressurized fuel is injected into the combustion chamber through the injection nozzle.
- Some fuel lubricates the nozzle’s needle valve and returns to the tank via the fuel overflow pipe.
Oil Level Check and Refill Procedure:
1. Place an oil pan under the tractor.
2. Remove the drain plug at the bottom of the transmission case and drain the oil.
3. Reinstall the drain plug.
4. Remove the filling plug and fill new oil up to the upper notch on the dipstick.
5. Run the engine for a few minutes, stop it, and recheck the oil level. Add oil if needed.
Type of Oil:
- Use only multi-grade transmission oil.
- Do not mix different brands of oil.
Transmission Fluid Capacity:
- 11.6 liters (3.1 U.S. gallons or 2.6 Imperial gallons).
This answer is automatically generated