Check Points Of Every 800 Hours; Adjusting Engine Valve Clearance; Check Points Of Every 1000 Hours Or 1 Year; Replacing Air Cleaner Element - Kubota WSM BX1880 Workshop Manual

2. GENERAL
2. Disconnect the fuel hoses and loosen the pipe
clamp to replace the fuel filter (5).
(1) Fuel pump
(2) Fuel filter
(3) Fuel line

1.8 Check points of every 800 hours

1.8.1 Adjusting engine valve clearance

• See "Checking engine vale clearance".
RELATED PAGE
4.1.2 Checking valve clearance on page 3-30
1.9 Check points of every 1000
hours or 1 year
Be sure to do the following servicing once every 1000
hours or yearly, whichever comes first.

1.9.1 Replacing air cleaner element

See "Cleaning air cleaner element".
RELATED PAGE
1.5.2 Cleaning air cleaner element on page 2-28
2-36
(4) Hose clamp
(5) Fuel filter
BX1880,BX2380,BX2680,RCK60B-23BX,RCK54-23BX,RCK48-18BX,RCK60D-26BX,RCK54D-26BX
CHECK AND MAINTENANCE
1.10 Check points of every 1500
hours
1.10.1 Checking injection pressure of fuel
injection nozzle
• See "Checking fuel injection pressure".
RELATED PAGE
4.4.5 Checking fuel injection pressure on page 3-36
1.11 Check points of every 2000
hours or 2 years
1.11.1 Flushing cooling system and
changing coolant
WARNING
To avoid serious injury or death:
• Do not remove the radiator cap while the
coolant is hot. When the coolant is cool, slowly
rotate the radiator cap to the first stop and allow
sufficient time for excess pressure to escape
before removing the radiator cap completely.
IMPORTANT
• Do not start the engine without coolant.
• Use clean, fresh soft water and the anti-freeze
to fill the radiator and the recovery tank.
• When mixing the anti-freeze with water, the anti-
freeze mixing ratio is 50%.
• Securely tighten the radiator cap. If the radiator
cap is loose or improperly fitted, water may leak
out and the engine could overheat.
BX1880
Coolant (with re-
Capacity
covery tank)
BX2380
Coolant (with re-
Capacity
covery tank)
BX2680
Coolant (with re-
Capacity
covery tank)
1. Stop the engine and let it cool down.
2. To drain the coolant, open the radiator drain plug or
the engine drain plug and remove the radiator cap.
The radiator cap must be removed to completely
drain the coolant.
3. After all coolant is drained, close the drain plug.
1. Periodic service
2.9 L
3.1 U.S.qts
2.6 Imp.qts
3.1 L
3.3 U.S.qts
2.7 Imp.qts
3.3 L
3.5 U.S.qts
2.9 Imp.qts
KiSC issued 03, 2019 A