Related Manuals for Congatec conga-SMX8-Mini
Summary of Contents for Congatec conga-SMX8-Mini
- Page 1 (Prototype Revision X.2) Sample Distribution Set for congatec SMARC 2.0 Development Quick Start Guide Revision 1.2 Copyright © 2019 congatec AG SX8M_SDS_q12...
-
Page 2: Copyright Notice
Copyright © 2019, congatec AG. All rights reserved. All text, pictures and product and this guide. In no event shall congatec AG be liable for any graphics are protected by copyrights. No copying is permitted without incidental, consequential, special, or exemplary damages, whether based written permission from congatec AG. -
Page 3: Warranty
(c) arising from course of performance, course of dealing, or usage of trade. congatec AG shall in no event be liable to the end user for collateral or consequential damages of any kind. congatec shall not otherwise be liable for loss, damage or expense directly or indirectly arising from the use of the product or from any other cause. -
Page 4: Pinout Description
The contents of the conga-SMX8-Mini (Prototype Revision X.2) sample distribution set are listed below: Note Part # Rev. Name Description Contact congatec technical support to get access to the pinout description. 007010 conga-SEVAL Evaluation carrier board for standard SMARC modules based on SMARC Specification 2.0 conga-SEVAL... -
Page 5: Hardware Setup
9. Connect an ATX Power Supply Unit (PSU) to the carrier board. 10. To start the system, switch the ATX PSU on. Note To enable serial downloader mode, set jumper X45 to position 2-3. Copyright © 2019 congatec AG SX8M_SDS_q12... -
Page 6: Boot Process
Software Boot Process The conga-SMX8-Mini boot process starts at Power On Reset (POR), where the hardware reset logic forces the ARM core to begin execution. The Starting Up on-chip boot ROM loads the bootloader. After loading, the bootloader is executed and performs basic system The conga-SMX8-Mini uses U-Boot as standard bootloader. -
Page 7: Additional Information
Description https://git.congatec.com/imx8m_early_access/meta-fsl-bsp-release mmcboot Boots the system from mmc (with the specified parameters for mmcboot), i.e. The conga-SMX8-Mini sources required to build the root filesystem image, eMMC, SD card kernel and bootloader are available at: mmcargs Configures the bootargs for mmcboot https://git.congatec.com/imx8m_early_access...
Need help?
Do you have a question about the conga-SMX8-Mini and is the answer not in the manual?
Questions and answers