Congatec conga-SMX95 Quick Start Manual

Sample distribution set for congatec smarc 2.1 development

Table of Contents

Download this manual

conga-SMX95 (Prototype Rev. X.2)

Sample Distribution Set for congatec SMARC 2.1 Development

Quick Start Guide

Revision 1.00

SX95_SDS_q100

1/7

Table of Contents

Need help?

Do you have a question about the conga-SMX95 and is the answer not in the manual?

Page 2: Intended Audience
Sample Distribution Set for conga-SMX95 (Prototype Rev. X.2) and and this guide. In no event shall congatec GmbH be liable for any incidental, how to set it up.
Page 3: Copyright Notice
These trademark holders are not affiliated congatec GmbH shall in no event be liable to the end user for collateral or with congatec GmbH, our products, or our website.
Page 5 Description 051690 conga-SMX95/i-6C-16G SMARC Module with NXP i.MX 95 six-core For information about the planned conga-SMX95 Mass Production (MP) eMMC32 processor. Features 6x ARM Cortex-A55 module variants, refer to the datasheet available at: @ 1.8GHz +1x ARM Cortex-M7 + 1x ARM Cortex-M33 + NPU, 16GB onboard LPDDR5 memory and 32GB onboard eMMC.
Page 6: Hardware Setup
3. Yocto Linux is pre-installed on the included SD card. 4. Optionally, use an USB to Serial RS-232 adapter (not included). 5. Optionally, congatec offers an LVDS to DVI converter board with matching power and data cables—see section 1.1 "Sample Distribution Set".
Page 7: Boot Process
Software Boot Process The conga-SMX95 boot process starts at Power On Reset (POR), where The software for the conga-SMX95 is available at: the hardware reset logic forces the ARM core to begin execution, starting from the on-chip boot ROM of the processor.