Installing The Tines; Setting The Tine Depth; Installing The Rear Guard - Toro ProCore SR54 Operator's Manual

Figure 29
1. Level
3. Turn the adjustable link body (if provided) to
raise or lower the link arm until the aerator levels
side-to-side.
Note:
Refer to the traction unit operator's
manual for additional adjustment procedures.
13

Installing the Tines

Parts needed for this procedure:
–
Tines (as required)
Procedure
You can choose from a wide selection of tines for the
aerator. Choose the tine type, size, and spacings
required for the job. Refer to the Parts Catalog for the
list of accessories.
1. Ensure that the stands or support blocks fully
support the aerator.
2. Turn off the traction unit engine and remove the
key.
3. Loosen the clamping bolts and remove the
previously used tines
g010854
(Figure 30).
1. Tine
4. Slide the new tines into the holes sized to fit the
tines selected. Never use small diameter tines
in the large diameter holes; the tines should fit
closely in the hole. Be sure to slide the tine up
into the head until it bottoms out.
Note:
Position hollow coring tines with the
ejection slot to the rear. Position solid tines with
the tine tip angle facing the machine
5. Tighten the clamping bolts firmly to secure the
tines. Do not use impact tools.
6. Set the tine angle for the new tines; refer
to Adjusting the Tine Angle (Models SR54,
SR54-S, SR70 and SR70-S) (page 26)
Adjusting the Tine Angle (Model SR72) (page
27).
7. Before aerating formal turf for the first time
after installing tines, test the aerator on a less
important area so that you can try alternative
traction unit gears and fine tune the adjustment
to achieve the hole spacing and turf appearance
desired.
14

Setting the Tine Depth

Models SR54-S and SR70-S
No Parts Required
Procedure
Set the tine depth; refer to
(Models SR54-S and SR70-S) (page
18
Figure 30
2. Clamping bolt
(Figure
Adjusting the Tine Depth
27).
g016131
30).
or