Removing The Storage Stands - Toro ProCore SR54 Operator's Manual

15
Installing the Rear Guard
Parts needed for this procedure:
1 Rear guard
4 Screw (3/8 x 3-1/4 inch)
12 Flat washer (0.438 x 1 inch)
4 Locknut
2 End cap
Procedure
1. Insert the end caps into the ends of the rear
guard tubes (Figure
Figure 31
1. Rear guard
2. End cap
2. Align the holes in the rear guard mounting tubes
with the holes in the aerator side plates
31).
Note:
On SR54-S and SR70-S models, mount
the ends of the tubes to the lower side plate
mounting holes if the aerator tine depth is set in
Position A (Figure
holes for depth setting Positions B or C.
31).
3. Upper mounting hole
4. Lower mounting hole
(Figure
32). Use the upper mounting
3. Secure the guard mounting tubes to the side
plates with 4 screws, flat washers, and nuts
(Figure 31).
Note:
Use the remaining washers, as required,
to fill any gap between the tubes and the aerator
side plates.
16
Removing the Storage
Stands
No Parts Required
Preparing Models SR54 and SR70
1. Raise the aerator roller(s) 7.5 to 15 cm (3 to 6
inches) off the ground. Place support blocks
under the roller(s).
2. Remove the bolts, lock washers, and nuts
securing the storage stands to each end of the
g016186
aerator (Figure
19
Figure 32
33).
g016181