Installing The Pto Shield - Toro ProCore SR54 Operator's Manual

Note:
Cut off more of the inside tube if it
protrudes into the cross and bearing section of
the outer tube.
14. Using the dimensions determined in step 11,
locate, mark and cut off just the safety shields to
expose the tubes
15. Carefully remove any burrs from the ends of the
tubes with a file and remove all the filings from
the tubes.
16. Grease the inside tube.
Note:
The telescoping tubes must always
overlap by 1/2 of their length during normal
operation and at least 1/3 of their length during
Figure 18
Figure 19
(Figure 20 and Figure
Figure 20
Figure 21
all working conditions. During transport, when
the drive line is not rotating, the telescoping
tubes must have a suitable overlap to maintain
alignment of the tubes and allow them to slide
freely.
9

Installing the PTO Shield

g237888
Parts needed for this procedure:
1 PTO shield
Procedure
1. Remove the 4 bolts, lock washers, and flat
washers secured to the rear of the aerator
g237889
gearbox
21).
g237890
1. PTO shield
2. Flat washer
3. Lock washer
2. Mount the PTO shield to the aerator gearbox
with the fasteners previously removed
22).
g237891
Align the access panel
shield to the top or the side depending on the
aerator frame configuration.
15
(Figure 22).
Figure 22
4. Bolt
5. Access panel
(Figure
g010849
(Figure
22) of the PTO