Product Overview; Specifications; Operation; Mixing And Pouring Concrete - Toro 22442 Operator's Manual

Product Overview

Specifications

Note:
Specifications and design are subject to
change without notice.
Width
Length
Weight
Maximum dry concrete load
64 cm (25 inches)
46 cm (18 inches)
34 kg (75 lb)
91 kg (200 lb)

Operation

Mixing and Pouring
Concrete
CAUTION
When full of concrete, the bowl is very heavy
and could unbalance the traction unit. The
traction unit could tip, seriously injuring you
or bystanders.
• Never use the cement bowl on a 200 or 300
series compact tool carrier without first
installing the counterweight, available from
your Authorized Service Dealer.
• Always keep the bowl close to the ground.
1. Lower the loader arms as far as possible while
tilting the bowl upward as far as possible.
2. Add up to 91 kg (200 lb) of dry concrete mixture.
3. Move the throttle lever to the F
4. If your traction unit has a speed selector and flow
divider, move the speed-selector lever to the
F position and move the flow-divider control
AST
to the 10 to 11 o'clock position (20 to 30 rpm).
5. Add the appropriate amount of water to the
concrete and move the auxiliary hydraulics lever
forward to mix.
6. When the cement is sufficiently mixed, move the
auxiliary hydraulics lever to N
drive to the work site.
7. Tilt the bowl forward and move the auxiliary
hydraulics lever rearward to dump the concrete.
8. When finished using the bowl, wash it before
the concrete sets.
Removing the Bowl from
the Auger Drive Head
1. Park the machine on a level surface.
2. Lower the bowl in the storage location.
3. Shut off the engine and remove the key.
4. Remove the bolt and nut securing the bowl to
the drive head
5. Start the engine and back the traction unit away
from the bowl.
7
position.
AST
EUTRAL
(Figure 5).
and slowly