Table of Contents
Advertisement
Operation
Installing the Attachment
Refer to the Operator's Manual for the traction unit for
the installation procedure.
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.
WARNING
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury. Fluid injected
into the skin must be surgically removed
within a few hours by a doctor familiar with
this form of injury; otherwise, gangrene may
result.
• Ensure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are tight
before applying pressure to the hydraulic
system.
• Keep your body and hands away from
pinhole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find hydraulic
leaks; never use your hands.
CAUTION
Hydraulic couplers, hydraulic lines/valves,
and hydraulic fluid may be hot. If you contact
hot components, you may be burned.
• Wear gloves when operating the hydraulic
couplers.
• Allow the machine to cool before touching
hydraulic components.
• Do not touch hydraulic fluid spills.
Removing the Attachment
1.
With the plow raised above the ground, shut off
the engine and remove the key.
2.
Remove the lower lynch pin and clevis pin
securing the blade to the plow.
Note:
To completely remove the blade, remove
both the upper and lower lynch and clevis pins;
refer to
Figure
3.
Swing the blade up and secure it using the lynch
and clevis pin as shown in
1. Lynch and clevis pin
2. Stand
4.
Tilt the plow forward and lower it to the ground
or trailer, with the stand and coulter supporting
the weight of the plow
5.
Disconnect the hydraulic hoses and remove the
plow as directed in your traction unit Operator's
Manual.
Installing a Blade
Toro offers several different blades and pullers.
Purchase a blade and puller from your Authorized
Service Dealer.
WARNING
The blade is sharp and can swing during
installation and removal, cutting, pinching, or
crushing hands or feet.
Wear gloves and work boots and securely
hold the blade.
1.
Park the machine on a level surface and engage
the parking brake (if equipped)
2.
Raise the plow about 1 m (39 inches) off the
ground and install the cylinder lock(s).
3.
Shut off the engine and remove the key
4.
Remove the 2 lynch pins from the clevis pins in
the blade bracket, then remove the clevis pins
(Figure
5) and the existing blade (if installed).
6
5.
(Figure
4).
Figure 4
3. Coulter
(Figure
4).
g247050
Advertisement
Table of Contents
