Servicing The Gear Lube - Toro 22911 Operator's Manual

Figure 14

Servicing the Gear Lube

Gear-lube type: SAE 90-140 API service GL-4 or GL-5
Capacity: 1.4 L (47 fl oz)
Checking the Gear-Lube Level
Service Interval: Every 25 hours
Before storage
1. Park the machine on a level surface, disengage
the auxiliary hydraulics lever, and lower the
attachment so that the plow is on the ground.
Engage the parking brake (if equipped).
2. Stop the engine and remove the key.
3. Check the clear glass gauge on the side of the
gear case (Figure
Note:
The gear lube should be at the level of
the red dot in the center of the gauge.
4. If the gear-lube level is low, remove the fill plug
(Figure 15) and fill the case with gear lube until it
is level with the red dot in the gauge.
Figure 15
1. Glass gauge
2. Drain plug
5. Replace the fill plug.
15).
3. Fill plug
Changing the Gear Lube
Service Interval: Every 200 hours/Yearly (whichever
1. Park the machine on a level surface, disengage
the auxiliary hydraulics lever, and lower the
attachment so that the plow is on the ground.
Engage the parking brake (if equipped).
2. Stop the engine and remove the key.
g005034
3. Prepare an appropriate container to catch the
used oil under the plow.
4. Remove the drain plug
oil to spill out into the container.
5. When finished, replace the drain plug, ensuring
that it is tight.
6. Remove the fill plug
with gear lube until it is level with the red dot in
the gauge.
7. Replace the fill plug.
g005035
11
comes first)
(Figure 15), allowing the
(Figure 15) and fill the case