Adesso 5100 Manual page 13

Before adding a suffix
Prefixes and suffixes Up to ten characters were added.
Add the prefix process:
Example 1
1, add a prefix byte character "®", ASCII code corresponding to the number of decimal 174.1. Scan"to enter / exit
the programming mode" to make the device into programming mode.
2. Scan"Configuring a prefix of the first byte."
3. Bytecode sequentially Scan the value "1", "7", "4."
4. Scan "to enter / exit the programming mode."
Add the suffix process:
Example 2add a suffix byte character is "$", ASCII code corresponding to the number of decimal 036
1. Scan "to enter / exit the programming mode" to make the device into programming mode.
2. Scan "configuration suffix first byte."
3. Successively scan byte code value "0", "3", "6."
4. Scan "to enter / exit the programming mode."
Add multiple byte prefix:
Example 3 to add more bytes prefix
1. Scan "to enter / exit the programming mode" to make the device into programming mode.
2. Scan "Configuring a prefix of the first byte."
3. The Scan followed the first one byte code value.
4. Scan "Configuration prefix first two bytes."
5. Successively scan the first two byte code value.4,5
6. Repeat step......
7. Scan "to enter / exit the programming mode."
Add multiple byte suffix:
Similar to adding multiple prefixes.
Clear all prefixes:
Scan "All Clear prefix" bar code.
Clear all suffixes:
Scan "All Clear prefix" bar code.
13 / 18