Adesso 5100 Manual page 11

Aimer setting
*Aimer Enable Enable
Enable Enable
Lighting configuration*Light Enable
Test Mode
After you configure a test mode, the device is automatically triggered every second decoding again.
Device is configured to blink test mode
Barcode length locking configuration
It supports up to six kinds of bar code type length locks
Add a single bar code type length locking configuration process:
Example 1, the locking QR code length is 32, QR barcode types byte values by type of bar code lookup table to
obtain 108.
1. Scan "to enter / exit the programming mode" to make the device into programming mode.
2. Scan "Configuring bar code type 1 length."
3. Successively scan bytecode value "0", "3", "2."
4. Scan "Configuring bar code type 1 byte values."
5. Bytecode sequentially scan the value "1", "0", "8."
6. Scan "to enter / exit the programming mode."
Add more length locking bar code type:
Example 3
1. Scan "to enter / exit the programming mode" to make the device into programming mode.
2. Scan "Configuring bar code type 1 length."
3. Successively sweep byte code value.
4. Scan "Configuring bar code type 1 byte values."
5. Successively sweep byte code value.
6. Scan "Configuring bar code type 2 length."
7. Successively sweep byte code value.
8. Scan"Configuring bar code type 2-byte value."
Enable
Enable Enable
*Cancel the test mode is configured to blink
Aimer prohibit prohibit
prohibit prohibit
Light prohibit prohibit
prohibit prohibit
11 / 18