Checking Battery Status; Recharging The Handheld - Texas Instruments TI-Nspire Getting Started

Checking Battery Status

To check the status of both the TI-Nspire™ Rechargeable Battery and the AAA
batteries in a handheld:
c
1. Press
5 4
2. Press
From an open document, press
Note:

Recharging the Handheld

To recharge the TI-Nspire™ Rechargeable Battery in a handheld, connect it to
either of the following power sources:
• A standard USB cable connected to a computer
• A standard, TI USB wall charger (sold separately in Europe and Asia)
The amount of time required to fully charge the battery may vary, but charging
normally takes about six hours. It is not necessary to remove the TI-Nspire™
Rechargeable Battery from the handheld to recharge it. The handheld operates
normally while it is attached to a charging source.
to access the Home screen.
to open the Handheld Status window.
~ 7 4
.
Configuring Handhelds 83