Advertisement
SETTING UP A VoIP NETWORK
A TalkSwitch VoIP network can be set up in 4 steps:
1. Connect a TalkSwitch or SIP-compatible gateway at each location.
2. Select a TalkSwitch to use as the SIP network server.
3. Assign phone numbers to each VoIP location.
4. Configure TalkSwitch to make and manage VoIP calls.
Connect TalkSwitch or SIP-compatible gateways
In order to create a VoIP network, a VoIP-equipped TalkSwitch or a VoIP
compatible gateway, such as a Mediatrix® 2102, is required at each location
instructions on page 2 describe how to do this.
Each location in a multi-location network can support up to 4 TalkSwitch units,
with a maximum of 32 local extensions (analog and/or IP phones) and 16 VoIP
lines
1The Mediatrix 2102 is a TalkSwitch-certified third-party SIP gateway that is ideal for small
2Up to 48 VoIP numbers can be assigned to the 16 VoIP lines.
4
2
per location.
Example: The following is a multi-location network where two locations are
equipped with TalkSwitch systems and a teleworker is equipped with a
Mediatrix 2102 device. TalkSwitch and the Mediatrix 2102 route VoIP calls
over the Internet, while local calls are routed over the traditional telephone
network.
Multi-location network with VoIP calling
FIGURE 2.
branch offices or teleworkers.
TALKSWITCH VOIP NETWORK CONFIGURATION GUIDE
1
. The
Advertisement
