Charge Indicator Lights; Buttons And Indicator Lights - Shark AI Robot RV2000 Series Owner's Manual

CHARGE INDICATOR LIGHTS

NOTE: If the low charge light is blinking red, there is not enough battery power for the robot to return to the dock.
Manually place the robot on the dock.
TIP: To preserve battery life, turn off the power switch if the robot will not be used for a long period of time. The robot
should be recharged at least once every three months. The switch must be in the ON position to charge the robot.
IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your robot on a small
section of the floor to ensure there is no scratching.
s h a r kc l e a n . c o m
In Use
Full Partial Low
Charge Charge Charge
(White) (White) (Red)
While
Charging
(White)
No Charge
or Off
The white charge indicator lights show how much
battery power is remaining.
While the robot is charging, both white LED lights
will flash. When charging is complete, both will
illuminate steadily. It may take up to 6 hours to fully
charge your robot.
If the robot is idle and away from the charging
dock for 10 minutes, it will enter Sleep Mode. The
indicator lights will turn off, but the battery and
Wi-Fi lights will remain on in sleep mode. Wake up
the robot by pressing any button.

BUTTONS AND INDICATOR LIGHTS

CLEAN BUTTON
Press to begin a cleaning
session. Press again to stop.
DOCK BUTTON
Press to stop cleaning and
send robot back to the
charging dock.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
White light: connected to
Wi-Fi.
Red light: not connected.
Flashing White: setup mode.
No light: not set up yet.
s h a r kc l e a n . c o m