Other Commands - Xeos XMR Series User Manual

Other Commands

Below is a list of other commands that can be sent via Iridium or serially to acquire additional
information, or configure the XMR. Remember to add the $ symbol ahead of any commands.
Command Parameters
ver ---
Status ---
sysInf ---
FactoryDefaults ---
batt ---
switch X 1/0
enable Y 1/0
ReportHour Hour (0 – 23)
RepMinute Minute (0 – 55)
ResetNow ---
XMR User Manual 1.1
Description
Show hardware and firmware versions.
Show operating status
GPS/Ird summary
Reset all to defaults and reset.
Show battery status
Switch component X on/off. No parameter lists components
Enable component Y on/off. Requires entry to Eng. Mode
Set/Show Daily Reporting Hour offset from UTC
Minutes offset past the hour for GPS/Iridium
Restarts the system. The effect is the same as restarting via
the magnet
27