Ascii Position (Type P) - Xeos XMR Series User Manual

Message Log Readout
Timestamp
BatteryV: 11.91
44.714272
-63.604870
Voltage Unloaded: 12.06
Location Log Readout
Timestamp
44.714400
-63.604902
Alarm: False
Bearing
Speed (km/h)
Speed (knots)
Altitude
SNR

ASCII Position (Type P)

In this format, only the most recent fix is sent at each interval, therefore it is most efficient to
have GPS and Iridium intervals equal.
P-type messages are approximately 39 bytes:
The message type used can be changed using the $msgenable command.
Position Readout
06221600
P
44.71441
-63.60495
49
348
XMR User Manual 1.1
Date and time in UTC of the latest position reading
Loaded voltage of the power supply; minimum battery voltage
observed during the previous Iridium transmission
Latitude of fix, decimal degrees
Longitude of fix, decimal degrees
Unloaded voltage of power supply; battery voltage data from
measurement taken just prior to the turning on of the Iridium
modem
Date and time in UTC of this specific position reading
Latitude of fix, decimal degrees
Longitude of fix, decimal degrees
Indicates if the device has determined if it is in an alarm state
Direction of movement determined by device
Speed measurement in kilometers per hour
Speed measurement in knots
Not used
SNR (Signal-to-noise ratio) of GPS Fix, higher is better (>37 is good)
Timestamp in UTC (Month/Day/Hour)
Type of message (Position)
Latitude of fix, decimal degrees
Longitude of fix, decimal degrees
SNR (Signal-to-noise ratio) of GPS Fix, higher is better
Unloaded voltage of device at the time of GPS Fix
14