Xmr Timer Intervals; Setting Timers - Xeos XMR Series User Manual

XMR Timer Intervals

The following are the default parameters for each mode.
Timer <T0> T1
SBD 1h 3m
GPS 1h 3m
ACS 2s 2s
Legend
SBD
GPS
ACS
T0 – T7
<T#>
#s/m/h/d
Min
Max
Timers
Timer 0 Normal
Timer 2 In-Motion
Timer 3 LiveTrack
Timer 4 No GPS Fix
Timer 5 Low Battery Used when XMR's power source drops below 7 Volts
Timer 6 Geofence
Timer 7 Watch Circ.
Note: Timer 1, is not used in the XMR. Timer Parameter named ACP is not used.

Setting timers

Examples:
To set the In-Motion Mode
commands:
To set the normal mode
hour interval, issue the following two commands:
The configuration above will result in the unit acquiring a GPS position every hour, which will
cause all 24 GPS positions to be sent in a single SBD transmission once daily.
XMR User Manual 1.1
T2 T3 T4
1m 1m 1h
20s 20s 2h
2s 2s 2s
SBD (Iridium) transmission interval
GPS acquisition interval
Acceleration Sample Rate
Timer number
Timer currently in use
Interval in seconds/minutes/hours/days
Minimum allowed interval for this timer
Maximum allowed interval for this timer
Used if none of the following modes are triggered
Triggered when the device has detected sufficient motion
Triggered by command for immediate fast tracking
Used when the GPS module continuously fails to acquire a fix
Triggers when the user's defined Geofence settings are triggered
Triggers when the device exits its set Watch Circle
$timer SYSTEM TIMER-MODE
SBD and GPS timer to a
$timer SBD
$timer GPS
SBD timer to a 1-day interval, and the
$timer SBD
$timer GPS
T5 T6 T7
2h 3m 10m
2h 1m 5m
2s 2s 2s
INTERVAL
10-minute interval, issue the following two
2 10m
2 10m
normal mode
0 1d
0 1h
Min-Max
25s-1d
20s-1d
1s-1m
GPS timer to a 1-
20