Generating Your Key; Enabling Encryption Use - Xeos XMR Series User Manual

Generating your Key

This process uses uCon Terminal Emulator, but any terminal emulator can be used.
Getting the COM Port
1. Connect the XMR to your PC via the required cable.
2. Take note of the COM port number in Control Panel → Device Manager
Connect Using Terminal Emulator (uCon)
1. Download the uCon Serial Console software
2. Install uCon and open the program
3. Connect to the XMR using the following settings
(right), use the COM port from the previous section.
4. Press Ok. Turn on echo by going to Config →
Miscellaneous (see below)
5. Enter your encryption passphrase by entering
$aky PASSPHRASE
The pass phrase must be exactly 32 characters long.
Note: This step cannot be done through Iridium.

Enabling Encryption Use

1. To enable encryption, send the command: $aenbl 1
2. To disable encryption, send the command: $aenbl 0
XMR User Manual 1.1 25