Confer Plastics 7200-G Assembly, Installation And Use Manual page 3

Slide the bottom hinge bracket up on to the bolts
Place washer over each bolt and start the
1/4-20
and tighten securely.
hex nut
Place the gate on edge and carefully install latch
Slide the top hinge bracket on to the bolts as
using a rubber mallet. It may require several hits
shown and tighten only enough to hold in place.
with rubber mallet.
Place the lower gate hinge post in to the lower hinge bracket. Rotate the top hinge bracket up and over the
top gate hinge post and tighten bolts.