Advertisement
Model #7200-G Gate for 7200 Ladder
7200 LADDER MUST BE ASSEMBLED AND ATTACHED TO POOL BEFORE GATE IS
If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferplastics.com
PARTS:
1-GATE
2-HINGE BRACKET
1-LATCH
1-LATCH PLATE
TOOLS REQUIRED: CORDLESS DRILL, 5/16" DRILL BIT, 1/8" DRILL BIT, PHILLIPS SCREWDRIVER,
9/16" OPEN END WRENCH
NOTE: 7200 LADDER MUST BE ASSEMBLED AND ATTACHED TO POOL BEFORE GATE IS
ATTACHED. SLIDE ROLLGUARD® TO INSIDE
Check building codes/permitting. Consult your local Building Department before installation of your pool and
equipment. Pool/equipment installation must comply with the codes of the authority having jurisdiction and may
require permits (e.g., building, plumbing, electrical, zoning, etc.).
Use for intended purpose only
• Use only as a gate for the #7200 swimming pool ladder.
Check that you have all required parts. Check the contents of the carton with the Parts List for this ladder. All
parts and hardware are required. If any parts are missing, DO NOT attempt to assemble or install the gate.
Instead, call Toll Free U.S. - 800-635-3213 or visit our web site at www.conferplastics.com for assistance.
Select an appropriate location - The ladder must be located on a level, solid base and in a location that will be in
full view of competent adult supervision when in use.
Follow all instructions
• For stable, correct assembly and installation, all instructions must be followed completely and in the sequence
shown.
• Follow the manufacturer's recommendations for the safe use of all hand tools and equipment used during
installation.
Cordless drill only - no corded drills near pool. Use a cordless drill for assembly and installation. To reduce the
risk of electrocution, NEVER use a corded drill in or around a pool.
Lift safely. When lifting awkward or heavy loads, have another person help you.
Double check after installation
• Before using the product, after assembly and installation, go over the instructions and procedures again to
make sure nothing has been overlooked.
• Make sure that safety labels are installed and legible.
Push the four 2-1/4" bolts through the pre-drilled holes located on the "OR" outside right ladder leg.
ATTACHED. SLIDE ROLL-GUARD TO INSIDE
5- 1/4-20 X 2- 1/4" BOLTS
5- 1/4-20 HEX NUT
5- 1/4" WASHERS
1 -1/4-20 PLASTIC ACORN NUT
Safe Installation
To reduce the risk of electrocution, drowning, entrapment, falls, or other serious
injury or death:
You may need to tap head of bolts to knock out plastic.
1 - PADLOCK
1 - #10 x 1-1/4" SCREW
Advertisement
