Polycom VVX 600 Phone Manual

Telstra VVX 600/601 Phone Guide
The changes between the VVX 600 and the VVX
601 is a simple hardware refresh. There are no
changes to the user functionality. This Phone
Guide is based on Firmware version 5.4.1.
Follow the instructions listed below to check your
Phone Firmware version.
If you are required to initially configure your IP
phone you will be advised of the Username and
Password. This information only needs to be
entered once via the QSetup soft key.
Tap the QSetup soft key
Tap the Server User field
Enter the Server User credentials (obtain this
information from Telstra.
This number will be your phone number)
Tap the Server Password field
Tap the Mode soft key and tap 123 (to select
numbers)
Enter the Server password (obtain this
information from Telstra)
Telstra VVX 600/601 Phone Guide | August 2016
Tap Save Config to Save the Config
You will now need to manually reboot the phone
Press the Home button
Tap Settings
Tap Basic, swipe your finger up the screen and
Tap Restart Phone
Tap the Yes soft key (to confirm)
Note 1: Restarting the phone may take a few
minutes
Note 2: If your phone has been preconfigured
the QSetup soft key will not be visible
Note 3: This is only required for phones that are
on DMS (Device Management System)
platform.
From the Home screen
Select Settings
Select Status
Select Platform
Select Application
Select Main
The Firmware Version will be listed on the
screen
Your VVX 600 Media phone supports a
Polycom USB camera with a Shutter to Open
and Close
Slot on the back of your
phone for Polycom USB
camera
Some VVX 600/601 may also have a Redial icon
configured
To enter the Home View main menu, press
To return to the Line View, press
Page 1