Initial Assembly; Assembly View - Quantum Q6 Edge 3 STRETTO Owner's Manual

Initial Assembly

Your power chair may require some assembly either
before initial use or after transportation. It may also require
disassembly to make some comfort adjustments. Figure 5
details those parts of the power chair that are designed
to be disassembled and assembled by an end user or by
a qualified caregiver before using the product or making
comfort adjustments.
NOTE: Any nylon insert lock nut removed during the
disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should
not be reused as it may cause damage to the nylon
insert, resulting in a less secure fit. Replacement nylon
insert lock nuts are available at local hardware stores or
through your Quantum Rehab Provider.
NOTE: If your power chair is equipped with a TB-Flex
Seat or a TRU-Balance® 3 Power Positioning System,
refer to the information provided in separate manuals.
MANDATORY!
Prevent controller harness damage! Avoid routing the
controller harness on the outside of the armrest pad.
Route the harness under the armrest or toward the
inside of the armrest pad. Use correct tie-down points
for controller harness to prevent the harness from
getting caught in the wheels, pinched in the seat frame,
or damaged when passing through doorways.
Armrest Angle
Adjustment
Figure 5. Assembly View
ASSEMBLY 11
Controller
Position