Advertisement
Initial Assembly
Your power chair may require some assembly either
before initial use or after transportation. It may also require
disassembly to make some comfort adjustments. Figure 3
details those parts of the power chair that are designed
to be disassembled and assembled by an end user or by
a qualified caregiver before using the product or making
comfort adjustments.
NOTE: Any nylon insert lock nut removed during the
disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should
not be reused as it may cause damage to the nylon
insert, resulting in a less secure fit. Replacement nylon
insert lock nuts are available at local hardware stores or
through your Quantum Rehab Provider.
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair.
NOTE: If your power chair is equipped with a TB-Flex
Seat, a Synergy Seat, or a TRU-Balance® 3 Power
Positioning System, refer to the information provided in
separate manuals.
WARNING!
Do not pick up the seat frame by the armrests. They are
free to pivot, and you may lose control of the seat if they
do so.
To install the seat:
1. Tilt the seat back and align the interfaces on the bottom
rear of the seat with the rear seat securement brackets
on the power base and secure with the hardware. See
figure 4.
2. Pivot the seat down and secure the front seat interface
into the top of the actuator with the detent pin.
WARNING!
Make sure the hardware and detent pin are properly
secured before using your power chair.
3. Install the controller and route the harness to the back of
the power base. See figure 3.
Figure 3. Q4 Assembly View
ASSEMBLY
9
Controller Position
Seat Height/Angle
Adjustment
Advertisement
