Volkswagen CC 2012 Workshop Manual page 43

– Secure fuel tank.
– Guide filler neck in between rear axle and body.
– Use suitable workshop equipment to prevent the securing
straps from turning while tightening the bolts.
– If metering pump - V54- is fitted, ensure that it is securely fas‐
tened to bracket.
– Ensure that the filler neck of the fuel tank is correctly inserted
into the opening in the body.
– Install breather lines and fuel lines free of kinks.
– After installing fuel tank, check that the supply, return and
breather lines are still clipped onto the fuel tank.
– Position the fuel tank together with securing strap on under‐
body, using the engine and gearbox jack - V.A.G 1383 A- .
– Ensure that bracket for exhaust system is seated correctly ⇒
Rep. gr. 26 ; Exhaust pipes/silencers; Assembly overview -
silencers .
– Use suitable workshop equipment to prevent the securing
straps from turning while tightening the bolts.
– Ensure that line connections are tight.
– Ensure connections are secured properly by pulling.
– Install rear axle ⇒ Running gear, axles, steering; Rep. gr. 42 ;
Rear axle; Lowering rear axle .
– Fit connector -A- onto four-wheel drive control unit - J492- .
– Fit connector -A- to right flange. Ensure connections are se‐
cured properly by pulling.
CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
Fuel supply system, petrol engines - Edition 05.2019
39
1. Fuel