Setup - WAGNER POWER TEX Owner's Manual

1. Line up the "unlock" symbol on the turbine with the guide
on the sprayer. Twist the two halves in opposite
directions until the "lock" symbol on the turbine lines up
with the guide on the sprayer.
3. Attach desired nozzle by threading it onto the end of the
sprayer.
5. Plug the power cord into an extension cord. Plug the
extension cord into a grounded outlet. Turn the switch to
ON (l).
The turbine will start up and air will blow from the nozzle.
No material will flow from the nozzle until the trigger is
pulled.
English

Setup

2. While facing the rear of the sprayer/ turbine assembly,
insert the hopper into the receptacle with the hopper
oriented as shown. Depending on what surface you plan
to spray, turn the hopper 1/4 turn in either direction to lock
it in place.
4. Slowly fill the hopper with the material you plan to use.
Be sure the sprayer/ turbine assembly is resting on a flat,
stable surface that is covered by a drop cloth.
6. Place the arm rest over your forearm. Aim the sprayer at
a scrap piece of wood or cardboard to test the spray
pattern.
4
Walls
Ceilings
Do not exceed fill
point as shown.