Playback - Samsung SCD77 Owner's Instruction Book

Playing back a Tape
Connecting to a TV which has no Audio and Video input jacks
You can connect your camcorder to a TV through a VCR.
1. Connect the comcorder and VCR with the Audio/Video cable.
The yellow plug : Video
The white plug : Audio(L)
The red plug : Audio(R) – STEREO only
2. Connect a TV with the VCR.
3. Set the power switch of camcorder to PLAYER.
4. Turn on the TV and VCR.
Set the input selector on the VCR to LINE.
Turn on the TV and select the channel reserved for your VCR on the TV.
5. Playback a tape.

Playback

You can play the recorded tape in PLAYER mode.
1. Connect a power source and set power switch to PLAYER.
Set the mode switch to CAMCORDER. (SCD75/D77 only)
2. Insert a tape you want to see.
3. Using (FF) and (REW) buttons, find the part of the tape you want to see.
4. Press the (PLAY/STILL) button.
The picture you recorded appears on the TV after a few seconds.
If the tape reaches its end during playback, the tape will rewind automatically.
Notes
It is best to decrease the volume of the built-in speaker when your camcorder is connected to the TV.
The playback mode (SP/LP) is selected automatically.
CAMCORDER VCR
1 ALARM IN 2 ALARM OUT 3 ALARM RESET 4 GND 5 TRIGGER OUT
TAPE END OUT 6 7 SERIES OUT 8 GND SERIES IN 9 10 1 SHOT REC IN
1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 10 10
OUT IN
OUT IN
S-VIDEO TV
S-VIDEO
VIDEO
(L)
AUDIO
(R)
PLAYER
ENGLISH
TV
ANTENNA
PLAY/
STILL
65